area. Then click on the SNMP button. 


statistics for your device, first confirm that it is selected in the Slots 

Farallon device that supports an SNMP agent. To see SNMP 

The EN Diagnostics utility also displays SNMP statistics for any 











both ends.


- For Thinnet make sure that the coaxial cable is terminated at 

- Disconnect from all network services

- Confirm that the cable is properly attached to the card


fails, check the following:


Technical Support at (510) 814-5000. If the cable connection test 

could indicate that your card has a bad component. Call Farallon 

If any test other than the cable connection test consistently fails, it 






that you are logged off from all network services.

For the cable connection test, connect to the network, but be sure   



terminator.) 

be sure to terminate both ends of the BNC connector with a 50-ohm 

disconnected from the network. (When disconnecting a thinnet card, 

For all but the Cable Connection test, you should be physically  


 

will run six tests on the card  that is selected in the Slots area.  

If the Test button is active, you can click on it and EN Diagnostics 





button will be grayed out.

when you click the Test button. If Tests are not available, the Test

The Tests area of the dialog box shows the results of tests initiated  



that is selected in the Slots area.


The Device Info area contains general information about the item 










card or adapter may be selected by clicking on its name.
   

that is selected (highlighted) in the Slots area. A Farallon Ethernet 

All of the other information in the dialog box pertains to the device  

cards or adapters that are installed or connected to your computer. 

The Slots area of the dialog box lists the names of Farallon 



adapter in the event of a problem.


This utility is an aid to diagnosing your Farallon Ethernet card or 



Farallon EN Diagnostics 2.3